Symmetric: if True, extrusion is centered at the input shape, and total length is Length Fwd. Reversed: reverses the extrusion to go against Dir. Solid: if True, extruding a closed edge or a closed wire will yield a solid. Length Rev: Additional length to extrude against Dir. If both Length Fwd and Length Rev are zero, the length of Dir vector is used. 'Normal' means Dir is perpendicular to plane of the input shape. 'Edge' means Dir is obtained from an edge (line) linked by Dir Link. Otherwise, Dir is read-only, and computed from the linked shape.ĭir Link: parametric link to a edge (line) that sets the direction of extrusion.ĭir Mode: sets how Dir is controlled. If Dir Mode is 'Custom', you can edit Dir. The Extrude shape is defined by the following parameters, which can be edited after its creation in Property editor.īase: the input shape (the shape upon which the Part Extrude was applied).ĭir: the direction to extend the shape. Each input shape is placed underneath its Extrude object. The Model tree will list as many Extrude objects as there were selected shapes. Set the direction and length and optionally other parameters (see the following Parameters section for more details).Īlternatively, the selection can be done after launching the tool, by selecting one or more shape from the list in the Tasks panel.Click on the Part Extrude button in the toolbar, or go to the Part → Extrude menu. ![]() Select the shape(s) in the 3D view or in the Model tree view.Extrude a shell of faces, will produce a Compsolid.Extrude a [ Draft ShapeString, will produce a compound of solids (the string is a compound of the letters which are each a solid).a Draft Wire), will optionally produce a shell (several joined faces) or if the parameter "solid" is "true" will produce a solid a Draft Wire), will produce a open shell (several joined faces) an open ended cylinder) or if the parameter "solid" is "true" will produce a solid (e.g. circle), will optionally produce a closed face (e.g. line, arc), will produce a open face (e.g. Extrude a Vertex (point), will produce a lineal Edge (Line).In most common scenarios, the following lists the expected output shape type from a given input shape type, ![]() ![]() The output shape type will vary depending on the input shape type and the options selected. Part Extrude extends a shape by a specified distance, in a specified direction.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |